With my recent success at building fan dipoles that are more “nested” than “fan”, I saw no reason why I couldn’t put up more than one element on my 20m band vertical to achieve a match on 10m. I ran up a 2.4m length of D10 comms wire up the side of the pole, around 2 inches away from the 20m quarter wave element. After trimming a few centimeters here and there, it tuned it at 1.3:1 SWR and all was well.
To make sure everything really was good, I applied a QRO carrier and watched in amazement as the SWR hovered for a few seconds before moving up and down and finally going off the scale with the Acom shutting down with an alarm (what a great amp that is!).
It took a while to track this down but it turns out the D10 military comms wire had melted at the guying point about half way up the 10m vertical element. I had tensioned it around one of the bolts on the steel three-way guy point to stop it flapping around and it decided to try melt the insulation and finally and weld itself onto it before blowing itself apart. The joys of QRO.
